WTB Perazzi TM1 LH buttstock or PFS

Looking for left hand buttstock for TM1 or PFS left hand grip out of wood. 14.25”-14.5” would be ideal- but I own a saw and glue so adding length or chopping off is not a concern.

 

Most TM1s I believe are neutral. If a neutral stock will work I have a few buttstocks and forarms and other misc. parts

 

She’s shooting about 3/8”-1/2” of cast off for a lefty. If I can’t find a dedicated left hand stock I might have to try a neutral wood stock and have it converted for pfs to bolt on. I don’t think they make a left handed grip for a tm1?

 

I can't say I've ever seen even a RH grip (palm swell) unless it was custom made. I would assume the same goes for any sort of offset. Could always get 1/8"+ by having someone bend it though.

 

I had a LH TM-1 from factory in the 80's.

 

I have a stock that may or may not be original Perazzi. In the pics I tried to capture the number 44 stamped on the front. I think it has a little bit of LH cast but I’m not good at recognizing it. The adjustable comb has the set screws on the left for a LH shooter and being RH I couldn’t make the stock work for me. The top of the stock behind the comb was broken off at some point and glued back on. I’ll try to load some pictures. The LOP is fairly short. I don’t like anything over 14” for myself. I don’t know exactly what it is however. I’ll take $200 shipped CONUS.

 

More pics

 

I have a neutral left hand stock that may work for you.

The former owner lightly sanded the right side of the stock presumably to get it closer to his face. (see picture)

The checkering is crisp and the comb is leather covered as shown.

$300.00 shipped.

Send PM if interested.

 

Thanks for the pics. A cheap donor stock has been located. Thanks.