Need tool to adjust a Ljutic JL2 Rib

I bought this Ljutic with a "JL2" Adjustable rib. Does anybody have a tool to adjust the rib...Please show it so I can make the tool.

 

I found this on a old post.
Discussion starter·#4·Aug 28, 2018
There is a hole by the front bead. You have to use an Allen wrench. 60-40 to well over 100%. Higher than a one touch can going

 

Thank you, Is there a tool for turning the screw that raises or lowers the front of the rib. The screw has notches machined 180 degrees apart which tells me the screw was designed for a tool to turn the screw.

 

Will 3/32nd work. If not go smaller. Possibly 5/64

 

Could you please take a picture of the screw area

 

Tell me what size it is and I'll send you an allen wrench to fit it

 

Thank you Anthony!
Is it not an allen wrench I need, It is a tool to turns the screw to raise or lower the rib's point of impact
The screw thread has machined part of the threads180 degrees apart for a flat tool can grip the screw and turn it to raise the rib up or down.
I wanted to see what the Ljutic designed, but I can make one.....I just didn't want to re-invent the wheel.

 

Call Mike Hugill at Ljutic.

His cell is

He's a fine guy and will help if he has one.

I would wait till 9am their time

Good Luck

 

I did call Ljutic and had a great conversation. They didn't design a tool to turn the screw. I will when it gets warmer and OI can work in the garage