F/S: Remington Competition Trap Stock 870, 1100, 1187, 58, 878 Parallel Comb

Remington 870 Competition straight trap stock. Walnut, matte finish, machine cut checkering, no recoil pad.

Stock is in excellent shape, only one or two minor dents and dings, checkering is still sharp, doubt there are many left out there in better shape (looks to be a takeoff from a new gun). If you were inclined to refinish it, it looks like there's some REALLY nice grain underneath that's being hidden by the factory finish; I think it would REALLY pop with an oil finish!

Parallel comb (the only Remington non-monte carlo stock Remington made with a parallel comb), uncut (1" pad should provide approx 14 3/8" LOP)

This stock can also be fit to 1100, 1187, and 1196 guns by drilling out the stock bolt hole with a 5/8" spade bit and fashioning a spacer with a section of PVC pipe. Really easier done than said, I can provide more detailed instructions if necessary, although it's really pretty simple, usually about a half hour job.

This stock will fit the following guns:
-Remington 870: 12ga, 16ga, and full frame 20ga (will not fit lightweight 20ga guns), use 8 5/8" stock bolt.
-Remington 58: All gauges, use 8 5/8" stock bolt.
-Remington 878, use 8 5/8" stock bolt.
-Remington 1100: 12ga, 16ga, and full frame 20ga (with previously mentioned modification, will not fit LT or LW 20ga guns)
-Remington 1187: 12ga (with previously mentioned modification)
-Remington 1196 (with previously mentioned modification)

I can complete the conversion/modification including a permanently installed walnut plug (removing the need to use a piece of PVC pipe) for an additional $25 at the buyer's request.

$215 shipped in CONUS

 

up