For sale PERAZZI MX dropout RH MONTE CARLO WOOD SET

Discussion in 'For Sale-Wanted to Buy' started by pete kostopoulos, Feb 21, 2025.

  1. pete kostopoulos

    pete kostopoulos Mega Poster

    This is a brand new from the factory Perazzi MX drop out trigger Monte Carlo Wood set
    This is SC3 Category wood
    it will fit an MX 8 . Mx2000 , mx3 special,
    it can fit a high-tech, but the receiver will be proud on both ends (3mm wider than regular Mx)
    L.O.P. 15.0 ”
    DAC 1.50”
    DAH 1.75”
    DAMC 2”
    COMES WITH STOCK BOLT
    This is for right hand,
    it has a slight palm swell
    I had the right side, checkered “Italian style” with a bit more checkering for GRIP
    Knicks dings or. scratches
    It’s pretty evident it was never mounted on a gun.

    This possibly needs a little fitting from a qualified technician which I can gladly help if you send me the gun .

    This stock is over $5000. If you were to purchase it from the factory of Perazzi

    I can also have the stock cut to your custom length of pull, and install a Kick-eez pad of your . choice.


    28000 shipped
    Insurance if desired is responsibility of purchaser
     

    Attached Files:

  2. Flyersarebest

    Flyersarebest Moderator Founding Member Forum Leader

    Tricky little bugger them there decimal points.
     
    Skeetwitholdbrownings likes this.
  3. Flyersarebest

    Flyersarebest Moderator Founding Member Forum Leader

    I was going to post that I would take it for the $280.00, but knew it was $2,800.00

    Just had to wait until the OP sent me a PM clarifying that.
     
  4. rennerize

    rennerize Mega Poster Founding Member

    For $280.00 I will take it
    Don
     
  5. Flyersarebest

    Flyersarebest Moderator Founding Member Forum Leader

    Really?
    IMG_0990.gif
     
  6. pete kostopoulos

    pete kostopoulos Mega Poster

  7. pete kostopoulos

    pete kostopoulos Mega Poster

  8. pete kostopoulos

    pete kostopoulos Mega Poster

  9. 1Dirt

    1Dirt Active Member

    What gun was it on?
    Thanks
     
  10. pete kostopoulos

    pete kostopoulos Mega Poster

    Never been mounted … FACTORY NEW
    Will fit the following
    MX 8 …. MX2000….. High tech …

    any MX with drop out trigger.
     
  11. pete kostopoulos

    pete kostopoulos Mega Poster

    Inscribed on the gun
     

    Attached Files:

  12. Jim B

    Jim B Active Member

    The picture of the stock reflects that it is for a serialized (148936) MX2000/8. It almost certainly came from the factory on an MX2000/8. This is a lower (not lowest) rib model. The comb would likely be somewhat low on the higher rib models. Plus, the receiver width on the MX2000 is narrower than the High Tech receiver. The stock would bolt up to a High Tech receiver, HOWEVER, the receiver metal would be proud to (wider than) the wood.
     
  13. pete kostopoulos

    pete kostopoulos Mega Poster

    I do state that the receiver of a high tech would be slightly “proud”. Also I do state what it will fit
    if there’s an interested buyer and they tell me what rib configuration they have I can gladly tell them what the dimensions will be.

    Mod Edit: I deleted the sarcastic first sentence.
    Flyersarebest
    Moderator