My Loading Bench

Discussion in 'Reloading Bench' started by dr.longshot, Jun 20, 2015.

  1. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    My reloading bench is a custom made 36"inch widex 24"in deep that has a MEC Super Sizer on the left and a MEC 8567 Reloader with Universal Charging Bar in the center and an Electronic Powder Scale to weigh powder and shot charges.

    I will not post a picture of it as it is a absolute TOP SECRET set up, for my Longshot Loads, and My 800-X
    Line back-up loads.

    I sent a box of my secret RIO longshot loads to Kansas, shooter was amazed on their performance, and he did not miss any targets from the parking lot, and his fellow shooters wanted to buy some of those RIO's, they asked him where he bought those RIO Shells. He said that is my secret, they are custom made for me.

    Gary Bryant DR.longshot
     
  2. HKMLOG32

    HKMLOG32 Active Member Founding Member

    Hey Doc, How about sharing your hot load with the forum we won't tell.
     
  3. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    RIO Hull, RIO Primer, Windjammer Wad, 35.5
    Longshot, 1 1/8th oz #6 shot, Pressures are less than a new AA Super Hdcp Shell, but 1550Fps, 10,000Psi

    Dr.longshot
     
  4. HKMLOG32

    HKMLOG32 Active Member Founding Member

    Thanks Doc we appreciate it.:p:p:p:p:p:p
     
  5. JGM

    JGM Member

    Personally I know of no club that would allow me to shoot #6 shot.
     
  6. Foster Brooks

    Foster Brooks Member

    Our club has a 7 1/2 shot size limit.
     
  7. Shooting Coach

    Shooting Coach Well-Known Member Founding Member

    upload_2018-9-1_22-22-11.jpeg

    upload_2018-9-1_22-22-32.jpeg

    upload_2018-9-1_22-22-58.jpeg

    My downsized bench. The 9000 sets on quick change bolts. Shot a lot of rifle and handgun, not so much in the last couple of years. Have been diverted to the shotgun side of shooting for the last several years.

    No wife around to complain about the wise use of space. LOL
     

    Attached Files:

  8. bob lowman

    bob lowman Mega Poster

    That's an impressive set up, very nice
     
  9. Sovrapposti

    Sovrapposti Well-Known Member

    Now, that's a loading bench.
     
  10. Sovrapposti

    Sovrapposti Well-Known Member

    My loader is bolted on a 22"x18" chopping board so I can move it off the bench and store it in a plastic bag when not in use.
    If I want to reload, I'll sit it inside a plastic tray to catch any accidents if that happens. Worked fine.