Beretta 682 hinge pin.

Discussion in 'Trapshooting Forum - Americantrapshooter.com' started by Trapper56, Dec 30, 2014.

  1. Trapper56

    Trapper56 Member

    I purchased a 682 for my son for what I think is cheap but I am told it may need a new hinge pin. Any thoughts on a gunsmith?
     
    Trapper56, Dec 30, 2014
    #1
  2. 90Tshooter

    90Tshooter New Member

    You could send it to Beretta but it will take eons to get it back. I would send it to Phillip's Gunsmith in Texas. (210) 313-5988. If it is a gun and broke I think he can fix it.
     
    90Tshooter, Dec 30, 2014
    #2
  3. CCfan

    CCfan Active Member

    Ditto on Phillips. He will be at the Cardinal Center shoots.
     
    CCfan, Jan 1, 2015
    #3
  4. Trapshooter79

    Trapshooter79 Member Founding Member

    You cant beat Phillips for price.
     
    Trapshooter79, Jan 2, 2015
    #4
  5. tm143

    tm143 New Member

    If you can wait until one of the Ohio Shoots there will be several gunsmiths that can get the job done.
     
    tm143, Jan 2, 2015
    #5
  6. biggun 682

    biggun 682 Active Member Founding Member

    If you wait till the Ohio state shoot you can get Beretta to do the work at a greatly reduced rate.
     
    biggun 682, Jan 4, 2015
    #6
    MODERATOR 1 likes this.
  7. Palos shooter

    Palos shooter Mega Poster Founding Member

    Sometimes you can take a allem key to the trunion and turn it a few degres and get a new surface .Look inside the recever to see the female side of the screw.All 682 have a adjustable trunion. beretta has larger trunions available from Coles
     
    Palos shooter, Jan 4, 2015
    #7
  8. 27ydgames

    27ydgames Active Member Founding Member

    Or you can reverse them. Left to right.
    Hey Lester
    Dan
     
    27ydgames, Jan 7, 2015
    #8
  9. Shooting Coach

    Shooting Coach Well-Known Member Founding Member

    What Dan said, just swap them out, left to right. Can't hurt, might help.
     
    Shooting Coach, Jan 14, 2015
    #9